|
A benchtop, high-speed whole rack tube decapper that can automatically remove and dispose of screwtop caps from a full 96-tube rack.
Alternatively, the screwtop caps can be held within the Xsd-96 while the user fills, or accesses, the tubes. Caps can then be automatically reinserted into the same tubes.
Optimal seal quality
Each cap receives the same torque to ensure optimal seal quality and consistency.
Thread is tracked precisely to avoid cap cross threading. By adjusting to the tube pitch for each manufacturer the Xsd-96Pro will ensure that caps are not cross threaded during recapping process.
Improve productivity and reduce the risk of cross contamination and repetitive strain injury
Cycle time is less than 15 seconds. Stripper plate eliminates the risk of splashing or aerosol.
Easily integrated or use alone
The Xsd-96pro can be used in either manual or automated mode.
With a colour control touch screen the Xsd-96Pro is simple to operate with easy to read visual cues for operation status, tube type selection and operation.
Integrate easily using built-in RS232.
Easy stage access, sensors ensure that a rack is always loaded in correct orientation.
A motorised stage allows for simpler integration. The rack set-down position is clear of the main housing to allow easy robot gripper access.
Mounting points provide a solid fixture for robotic integration.
Compact design
The Xsd-96pro will fit inside an environmental control cabinet.
Multi tube capability
Compatible with all 96-format screwcap tubes from major suppliers.
Select tube type using the control panel and the Xsd-96Pro will automatically adjust settings for required tube height and thread pitch. Pre-defined settings available for many tubes including those supplied by all major manufacturers.
Advanced error recovery
Any decapping faults are detected automatically.
|
